You should note that roof replacement does not only involve adjusting and nailing down the shingles. As such, an effective roofing requires a relevant material technology and an integrated system approach which ensures that your home is properly protected. Notably, a successful roof installation requires a huge commitment which is why you need to have reliable knowledge about the entire re-roofing process. Such knowledge can be very beneficial to any homeowner since it helps you stay on the lookout for possible installation pitfalls. Also, you will not suffer from costly surprises during the installation process. Below are seven steps which residential roof repair in Dallas uses to ensure a successful roof replacement.
1. Property Protection
Your first job should be to ensure that your home is protected throughout the replacement process. The things you need to protect includes the nearby trees, plants, walls and house sidings. To ensure that you have ample protection you can use protection plywood and tarps.
2. Removal of the existing roofing material
The second step involves the safe removal of the old shingles to pave the way for new installation. After removing the shingles, the get a chance of inspecting the wood decking and determine whether it requires replacement.
3. Roofing Inspection
When inspecting the wood decking, you should look out for any rotten or wet wood and replace them with fresh wood to ensure that your roofing has a strong base. With a solid roofing base, you are assured that the shingles will remain intact. The wood sheeting should also be inspected to ensure that it is properly attached to the roof rafters. The residential roof repair in Dallas will go an extra mile by checking for missing nails while removing the old roofing material. If this is not done, you can experience numerous bumps on your roof after a few weeks.
4. Roof Surface preparation
After proper inspection and replacement of wood decking, you will need to install drip edge at each edge of your roof. This ensures that rain water does not get beneath the roof through the edges. Also, you should install water and ice shield which is stuck in the wood decking thus preventing any leakages. After installing the shield, you should then cover the rest of the roof with roofing felt which prevents the shingles from getting stuck in the wood.
5. New Shingles Installation
After completing the above steps, the roofing base is ready, and new roofing material can be installed. The installation should start from the bottom going up. After the installation, you should counter flashing and installation of ridge vents, ridge capping.
6. Site Cleaning
The site should be left tidier than it was found to ensure that your house and yard remains clean and presentable.
7. Final Inspection
After completing these steps, you should make a final inspection to ensure that the roof replacement has been done perfectly and meets your expectations.